CDTNS - LIQUEFIED PETROLEUM GAS WITH METHYL (SUPDAT)
- MSDS: CDTNS
- Manufacturer: BOC GROUP INC
- Product Name: LIQUEFIED PETROLEUM GAS WITH METHYL (SUPDAT)
- National Stock Number: 6830-00N073086
Product Identification
Product ID:LIQUEFIED PETROLEUM GAS WITH METHYL (SUPDAT)
MSDS Date:03/30/1995
FSC:6830
NIIN:00N073086
MSDS Number: CDTNS
Responsible Party
MURRAY HILL, NJ 07974
US
Emergency Phone: 908-464-8100;800-424-9300(CHEMTREC)
Info Phone: 908-464-8100
Cage: HO796
Contractor
Telephone: 908-464-8100
Cage: HO796
Ingredients
PETROLEUM GAS (LIQUEFIED); (LIQUEFIED PETROLEUM GAS)
CAS: 68476-85-7
RTECS: SE7545000
Fraction By Weight: 56%
OSHA PEL 1000 PPM
ACGIH TLV: 1000 PPM
PROPYNE, MIXED W/PROPADIENE; (METHYL ACETYLENE-PROPADIENE
CAS: 59355-75-8
RTECS: UK4920000
Fraction By Weight: 44%
OSHA PEL 1000PPM
ACGIH TLV: 1000PPM/1250STEL
MAY RESULT, EVENTUALLY LEADING TO CONVL, COMA, &
RTECS: 9999999ZZ
DEVELOPMENTAL ABNORMALITIES IN HUMANS AND
RTECS: 9999999ZZ
REMOVE CONTAMD
RTECS: 9999999ZZ
KEEP VICTIM CALM & WARM.
RTECS: 9999999ZZ
PROMPT MED ATTN IS
RTECS: 9999999ZZ
BE EQUIPPED W/NIOSH APPRVD SCBA. CONSCIOUS PERSONS
RTECS: 9999999ZZ
QUICK REMOVAL FROM CONTAMD AREA IS MOST IMPORTANT.
RTECS: 9999999ZZ
MOUTH-TO-MOUTH RESUSCITATION & SUPPLEMENTAL OXYGEN.
RTECS: 9999999ZZ
IF LEAK IS IN CNTNR/CNTNR VALVE, CONTACT APPROP
RTECS: 9999999ZZ
LOCATION.
RTECS: 9999999ZZ
PIPING/SYS. DO NOT HEAT CYL BY ANY MEANS TO
RTECS: 9999999ZZ
TRAP IN DISCHARGE LINE TO PVNT HAZ BACK FLOW INTO
RTECS: 9999999ZZ
WELL-VENT AREA AWAY FROM HEAVILY TRAFFICKED AREAS &
RTECS: 9999999ZZ
TO EXCEED 125F(52C). CYL SHOULD BE STORED UPRIGHT &
RTECS: 9999999ZZ
FULL & EMPTY CYLS SHOULD BE SEGREGATED. USE "FIRST
RTECS: 9999999ZZ
BEING STORED FOR EXCESS PERIODS OF TIME. POST "NO
RTECS: 9999999ZZ
BE NO SOURCES OF IGNIT IN THE STOR/USE AREA. FUEL
RTECS: 9999999ZZ
ACETYLIDES, SUCH AS COPPER, SILVER, MAGNESIUM/THEIR
RTECS: 9999999ZZ
PAMPHLET P-1. NEVER CARRY COMPRESSED GAS CYL/CNTNR
RTECS: 9999999ZZ
CAR/TRUCK, VAN/STATION WAGON. LEAK CAN RSLT IN FIRE,
RTECS: 9999999ZZ
PROVINCIAL REGS, AS APPLIC, FOR LIMITS WHICH MAY BE
RTECS: 9999999ZZ
LEAKS EXISTS, ALL ELEC EQUIP MUST BE RATED FOR USE IN
RTECS: 9999999ZZ
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE:EYE:CONT W/LIQ MAY CAUSE
FROSTBITE, IRRIT/BLNDNESS. SKIN:CONT W/LIQ WILL CAUSE
FROSTBITE/IRRIT. INGEST:UNLIKELY. EFTS OF INGEST ARE UNKNOWN.
HOWEVER MINIMAL HLTH EFTS ARE ANTIC. CONSULT PHYS FOR
TREATMENT/CONT LOC POIS CTL CTR. INHAL:THIS GAS MIX IS CNS DEPRESS
& IRRITANT. INHAL OF LOW CONCS MAY (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HLTH HAZ:CAUSE EXCITEMENT & DISORIENTATION. IN
HIGHER CONCS, THIS MIX MAY ACT AS ASPHYXIANT SO AS TO EXCLUDE ADEQ
SUPPLY OF OXYG TO LUNGS, CAUSING UNCON & POSSIBLY DEATH. EFTS OF
OXYG DEFICIENCY RSLTG FROM SIMPLE ASPHYXIANTS MAY INCL:RAPIDBRTHG,
DIMINISHED MENTAL ALERTNESS, IMPAIRED MUSCULAR COORDINATION,
(SUPDAT)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
First Aid
First Aid:EYES:NEVER INTRODUCE OIL/OINTMENT INTO EYES W/OUT MED ADVICE!
IN CASE OF FREEZING/CRYOGENIC "BURNS" BY RAPIDLY EVAP LIQ. DO NOT
WASH EYES W/HOT OR EVEN TEPID WATER! REMOVE VICTIM FROM SOURCE OF
CONTAM . OPEN EYELIDS WIDE TO ALLOW LIQ TO EVAP. IF PAIN IS
PRESENT, REFER VICTIM TO OPHTHALMOLOGIST FOR FURTHER TREATMENT &
FOLLOW UP. IF VICTIM CANNOT TOLERATE LIGHT, PROTECT EYES W/LIGHT
(ING 5)
Fire Fighting
Flash Point Method:CC
Flash Point:-144F,-98C
Lower Limits:3.0%
Upper Limits:11.0%
Extinguishing Media:WATER FOG, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:NIOSH APPRVD SCBA & FULL PROT EQUIP . DO NOT
EXTING. KEEP CYL COOL W/WATER FOG. IF FLAME IS EXTING, REMOVE ALL
SOURCES OF IGNIT & ALLOW CONTENT (SUPDAT)
Unusual Fire/Explosion Hazard:THIS GAS IS HVR/AIR & MAY TRAVEL
CONSIDERABLE DISTANCE TO IGNITION SOURCE. MAY BURN WITH AN ALMOST
INVISIBLE FLAME IN BRIGHT LIGHT.
Accidental Release
Spill Release Procedures:WARNING:ANY LEAKS OF MAPP PRESENT GREAT DANGER
OF EXPLO/FIRE. KEEP SOURCES OF IGNIT AWAY. EVAC ALL PERS FROM
AFFECTED AREA. USE APPROP PROT EQUIP. IF LEAK IS IN USER'S EQUIP,
BE CERTAIN TO PURGE PIPIN G W/INERT GAS PRIOR TO ATTEMPTING
REPAIRS.(ING 11)
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:EARTH BOND & GROUND ALL LINES & EQUIP
ASSOC W/FUEL GAS SYS. ELEC EQUIP SHOULD BE NON-SPK & EXPLO PROOF.
USE ONLY IN WELL-VENTILATED AREAS.
Other Precautions:VALVE PROT CAPS MUST REMAIN IN PLACE UNLESS CNTNR IS
SECURED W/VALVE OUTLET PIPED TO USE POINT. DO NOT DRAG, SLIDE/ROLL
CYL. USE SUITABLE HAND TRUCK FOR CYL MOVEMENT. USE PRESS REGULATOR
WHEN CONNECTI NG CYL TO LOWER PRESS(<250 PSIG)(ING 13)
Exposure Controls
Respiratory Protection:NIOSH APPROVED RESPIRATOR APPROPRIATE FOR
EXPOSURE OF CONCERN . RESP PROT IS NOT NORMALLY REQD. DO NOT ENTER
AREA OF HIGH MAPP CONC UNTIL FIRST PURGING W/INERT GAS & THEN
VENTILATING WITH AIR.
Ventilation:PROVIDE LOC EXHAUST/MECH VENT IF WELDING/CUTTING IN
CONFINED AREAS. IF GAS IS HNDLD ROUTINELY WHERE POTNTL FOR (ING 24)
Protective Gloves:LEATHER GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPRVD EYE WASH & DELUGE SHOWER . APRON
WHEN WELDING, CUTTING OR BRAZING. FILTER LENSES SHADE #41 DARKER.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
MFR TRADE NAME/PART NO:ACETYLENE PROPADIENE. FIRE FIGHT PROC:TO VENT.
INCR VENT TO PVNT FLAM MIX FORMATION. MATLS TO AVOID:POTASSIUM
PERMANGANATE. EFTS OF OVEREXP:FAULTY JUDGEMENT, DEPRESS OF ALL SENS
ATION, EMOTIONAL INSTABILITY, & FATG, AS ASPHY PROGRESSES, NAUS,
VOMIT, PROSTRATION, & LOSS OF CONSCIOUSNESS (ING 3)
Chemical Properties
Boiling Pt:B.P. Text:>-54F,>-48C
Melt/Freeze Pt:M.P/F.P Text:-184F,-120C
Vapor Pres:97PSIA@70F
Spec Gravity:0.571 (LIQUID)
Evaporation Rate & Reference:NOT AVAILABLE
Solubility in Water:SLIGHT
Appearance and Odor:A COLORLESS GAS WITH A CHARACTERISTIC, UNPLEASANT
ODOR.
Stability
Stability Indicator/Materials to Avoid:YES
NATURAL RUBBER, COPPER ALLOYS ABOVE 65% COPPER, SILVER, MERCURY,
HALOGENS, ACIDS, METALLIC SODIUM, POTASSIUM, (SUPDAT)
Stability Condition to Avoid:HIGH TEMPERATURES. PRODUCT WILL START TO
DECOMPOSE AT 815F(435C).
Hazardous Decomposition Products:MAY PRODUCE ACETYLIDES WHEN IN CONTACT
WITH SILVER, MAGNESIUM, OR COPPER ALLOYS ABOVE 65% COPPER.
Disposal
Waste Disposal Methods:DISP MUST BE I/A/W FED, STATE & LOC REGS . DO
NOT ATTEMPT TO DISPOSE OF RESIDUAL/UNUSED QTYS. RETURN IN SHIPPING
CNTNR PROPERLY LBLD, W/ANY VALVE OUTLET PLUGS/CAPS SECURED & VALVE
PROT CAP IN PL ACE TO BOC GASES/AUTH DISTRIBUTOR FOR PROPER DISP.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.